52 HP 2012fc Modular Smart Array user guide • January 2013

4. In the terminal emulator, connect to controller A.

5. Press Enter to display the CLI prompt (#).

6. At the prompt, type the following command to set the values you obtained in Step 1

for each Ethernet management port, first for controller A and then for controller B:

where:

■ address is the IP address of the controller

■ netmask is the subnet mask

■ gateway is the IP address of the subnet router

■ a|b specifies the controller whose network parameters you are setting

For example:

7. Type the following command to verify the new IP addresses:

Network parameters, including the IP address, subnet mask, and gateway address

are displayed for each controller.

8. Disconnect from the CLI and exit the emulator.

set network-parameters ip address netmask netmask gateway gateway

controller a|b

# set network-parameters ip 192.168.0.10 netmask 255.255.255.0

gateway 192.168.0.1 controller a

# set network-parameters ip 192.168.0.11 netmask 255.255.255.0

gateway 192.168.0.1 controller b

show network-parameters

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 87 88

Kommentare zu diesen Handbüchern

Keine Kommentare

Powers ES400XBY Tempering Valves with Internal & Exte Handbücher

Bedienungsanleitungen und Benutzerhandbücher für Zubehör fürs Wasser Powers ES400XBY Tempering Valves with Internal & Exte.
Wir stellen 1 PDF-Handbücher Powers ES400XBY Tempering Valves with Internal & Exte zum kostenlosen herunterladen nach Dokumenttypen zur Verfügung Bedienungsanleitung