Hp SmartStart-Software Bedienungsanleitung PDF herunterladen (Seite 5)

Overview 5

Supported hardware

• Servers. ProLiant G6 and later Servers that include an iLO or RILOE management device with a

minimum of 256 MB memory with any of the supported operating systems and with access to an iLO

virtual floppy drive, CD drive, or USB device.

• Adapters. The following HP ProLiant Gigabit Ethernet Multifunction Server Adapters are supported.

o HP NC382T PCI Express Dual Port Multifunction Gigabit Server Adapter

o HP NC382i Integrated Quad Port PCI Express Gigabit Server Adapter

o HP NC382m Dual Port 1 GbE Multifunction BL-c Adapter

iSCSI targets

All iSCSI targets supported by the Linux software initiator are supported by HP. Among HP branded

targets, those supporting iSCSI Boot are as follows:

o AiO family (http://www.hp.com/go/aiostorage)

o MSA SAN Storage Array product line (http://www.hp.com/go/msa)

o EVA4400 with the mpx 100b iSCSI Connectivity Kit (http://www.hp.com/go/eva)

For more information on iSCSI see the iSCSI (http://www.hp.com/go/iscsi

)website.

Limitations and known issues

The following are limitations to iSCSI boot for Linux.

• DNS is not supported

Installation

• On some blade systems, after the system is booted and the GUI is started, the system console on a

KVM switch may report that it is in an unsupported mode. The iLO2 integrated remote console works

fine. This is a problem with the SLES 10 installation procedure and not with the iSCSI boot

installation procedure.

• After booting a system over iSCSI, if the SmartStart Linux PSP is installed it changes the default boot

kernel in the boot loader conf file /boot/grub/menu.lst. The PSP default kernel does not support

iSCSI boot. Update the /boot/grub/grub.conf to make the default boot kernel point to the entry 0.

• If PXE is used to install the operating system on an iSCSI target for a c-Class BladeSystem, disable

the internal disk controller with RBSU (F9 during POST). After the install is complete, the internal

controller can be re-enabled.

System hangs

• After a server is booted over iSCSI, do not bring down the network interface that iSCSI is using or a

system hang results.

• Attempting to boot from an iSCSI disk that has no operating system installed on it may result in a

system hang.

• If the system crashes, the diskdump utility that would normally take a system dump will not work on

an iSCSI booted system.

Other

1 2 3 4 5 6 7 8 9 10 ... 28 29

Keine Kommentare

Hp SmartStart-Software Bedienungsanleitung Seite 5