HP Remote Graphics Software (RGS) Bedienungsanleitung PDF herunterladen (Seite 163)

Unless this command line option is used to change the logSetup file, the default logSetup file in the

Sender installation folder (C:\Program Files\Hewlett-Packard\Remote Graphics Sender) is used. The

first few lines of logSetup are shown in

Figure 6-32 Remote Clipboard log entries for cut and paste

on page 145.

Figure 6-34 logSetup file

The highlighted, uncommented line specifies that INFO-level logging is used. If another logging level is

required, edit the file to replace INFO with any of the following: DEBUG, WARN, ERROR, or FATAL.

NOTE: The logSetup file is set to read-only during Sender installation, so you’ll need to uncheck the

Read-only property to edit the file.

NOTE: In order to log Remote Clipboard activities on the Sender, DEBUG-level logging (not the

default INFOlevel logging) must be specified in the logSetup file.

ENWW

Receiver and Sender logging

147

1 2 ... 158 159 160 161 162 163 164 165 166 167 168 ... 242 243

Keine Kommentare

HP Remote Graphics Software (RGS) Bedienungsanleitung Seite 163