Hp Neoview Release 2.3 Software Bedienungsanleitung PDF herunterladen (Seite 58)

Starting the Client on Linux Systems

Use this shell command to start the Transporter Client. You specify the control file depending

on where the file resides. If the control file is not found, Transporter exits with an error.

• The control file is in $NVTHOME/conf:

jtrans.sh {-run | -recover}MyControlFile.txt

• The control file is in the current directory:

jtrans.sh {-run | -recover} ./MyControlFile.txt

• The control file is in a directory you specify — in this case, my/trans/dir:

jtrans.sh {-run | -recover} /my/trans/dir/MyControlFile.txt

Starting the Client on Windows Systems

Type this at the Command prompt on a Windows system to start the Transporter Client. You

specify the control file depending on where the file resides. If the control file is not found,

Transporter exits with an error.

• The control file is in $NVTHOME\conf. This is the default.

jtrans.bat {-run | -recover} MyControlFile.txt

• The control file is in the current directory:

jtrans.bat {-run | -recover} .\MyControlFile.txt

• The control file is in a directory you specify — in this case, my/trans/dir:

jtrans.bat {-run | -recover} /my/trans/dir/MyControlFile.txt

Command prompt on a Windows system

1. Click Start –> Run

2. In the Open text box, type cmd.exe

Stopping the Client

The Transporter client stops automatically when a data movement operation directed by a control

file has completed. If you need to abruptly stop a running data movement operation, use this

command:

• For Linux: stopjtrans.sh MyControlFile.txt

• For Windows: stopjtrans.bat MyControlFile.txt

You can recover this operation later, unless the job to recover involves one of these:

• An extract operation

• A load operation using a staging table

• A load operation with the “noaudit” (page 51)

option set to true.

• A load operation using a named pipe or JMS trickle feed source.

For more information about job recovery, refer to “Job Recovery” (page 67).

The Transporter Job

The units that make up a control file are called jobs. A job is a load or extract operation consisting

of several job entries.

A job entry is a unique source/target pairing consisting of:

58 Load and Extract Operations

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 109 110

Keine Kommentare

Hp Neoview Release 2.3 Software Bedienungsanleitung Seite 58