HP 34811A Bedienungsanleitung PDF herunterladen (Seite 43)

Configuring the HP 33120A Function/Arbitrary

Waveform Generator

HP BenchLink/Arb supports both RS-232 and IEEE-488 communications

from the PC to the HP 33120A Function/Arbitrary Waveform Generator.

This section describes how to set up your function generator so that

communications can be established when you run HP BenchLink/Arb.

Using the function generator front panel, the instrument must be placed

in the HP-IB or RS-232 interface mode. If using HP-IB, the function

generator must be given a unique address.

The HP 33120A Function Generator User’s Guide contains complete

descriptions of these procedures. The general procedure to set the

interface is:

Shift

Menu On/Off 1 Turn on the function generator menu.

A: MOD MENU

< < 2 Move across to the I/O Menu.

E: I/O MENU

∨

> 3 Move down and across to the Interface command.

2: INTERFACE

∨

4 Move down to select HP-IB or RS-232 interface parameters. If choosing

RS-232, you must also check the baud rate and parity commands in the

I/O Menu. The baud rate default is 9600; the parity default is none with 8

data bits.

Enter 5 Save the changes. For more information about these menus, see your

function generator user’s guide.

Chapter 3 Using HP BenchLink/Arb

Configuring the HP 33120A Function/Arbitrary Waveform Generator

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 69 70

Keine Kommentare

HP 34811A Bedienungsanleitung Seite 43