HP DL280 Betriebsanweisung PDF herunterladen (Seite 43)

System BIOS configuration 43

• All memory modules are properly installed.

• If you have installed a PCI accessory board, verify that the board is firmly seated and any

jumpers on the board are properly set. Refer to the documentation provided with the accessory

board.

• All internal cabling and connections are in their proper order.

• If you have changed the jumper on the system board, verify that each is properly set.

If the POST failure occurs after installing an accessory, perform the following steps:

1. Perform the pre-installation procedure described on page 45.

2. If necessary, remove any expansion boards, assemblies, or cables that prevent access to the

system components.

3. Check the following conditions:

a. If you have installed an expansion board, verify that the board is firmly seated in its slot and

any switches or jumpers on the board are properly set. Refer to the documentation provided

with the expansion board.

b. All internal cabling and connections are in their proper order.

c. If you have changed any jumper block on the system board, verify that each one is properly

set.

4. Perform the post-installation procedure described on page 46.

5. Turn on the monitor.

6. If the server still does not work, repeat step 2.

7. Remove all accessories, except the primary boot hard disk drive.

8. Repeat steps 4 and 5.

If the server now works, replace the boards and accessories one at a time to determine which

one is causing the problem.

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 49 50

Keine Kommentare

HP DL280 Betriebsanweisung Seite 43