HP SN1000E Installationsanleitung PDF herunterladen (Seite 6)

To install an HBA into a server:

1. Power off the server.

WARNING! Disconnect the server from the power source before installing the HBA. To

reduce the risk of personal injury from hot surfaces, allow the internal server or workstation

components to cool before touching.

2. Remove the screws on the server cover, and then remove the cover.

3. Wearing an anti-static wrist strap, remove the blank panel from an empty PCI slot.

NOTE: The HBA comes with a standard PCI bracket installed. A low-profile bracket is included

in the box with the HBA. The low-profile mounting bracket is shorter than the standard bracket:

approximately 7.90 cm (3.11 inches) compared to 12.06 cm (4.75 inches).

4. If you require a different mounting bracket, change the bracket as follows. Otherwise, proceed

to Step 5.

a. Remove the mounting bracket screws from the top of the HBA.

b. Remove the bracket and store it for future use.

c. Align the new mounting bracket tabs with the holes in the HBA.

IMPORTANT: Be careful not to push the bracket past the transceiver housing grounding

tabs. Ensure that the LEDs are aligned with the holes in the bracket.

d. Replace the screws that attach the HBA to the bracket.

5. Insert the HBA into the empty PCI slot. Press firmly until the HBA is seated.

NOTE: In some HP server models, only PCle HBAs can be inserted in the optional PCLe riser

cards or cages. For instructions on installing the riser card or cage, see your server

documentation.

6. Using the panel clip, secure the HBA mounting bracket to the cover.

7. Replace the server cover and tighten the screws.

8. Attach the media:

a. Connect one end of the fiber optic cable to the LC connector on the HBA.

b. Connect the other end of the cable to the Fibre Channel device.

NOTE: The HBA does not allow data transmission on an optical link unless the link is

connected to a similar or compatible laser product (that is, multimode to multimode).

9. Verify the installation and apply power to the server:

a. Verify that the HBA is securely installed in the server slot.

b. Verify that the media is attached.

c. Plug in and power on the server.

d. Observe the LEDs for POST status results.

For information about the LED indicator code, see “HBA LED POST states” (page 17).

6 Installing an HBA

1 2 3 4 5 6 7 8 9 10 11 ... 31 32

Keine Kommentare

HP SN1000E Installationsanleitung Seite 6