HP 10BASE-T Installationshandbuch PDF herunterladen (Seite 51)

Test Node Accessibility.

To verify that other nodes can be accessed from the router module, use

the NCL Ping command.

Ping command can be used on a router with IP routing enabled to test

whether particular routers and end nodes can be reached. Use the

specific IP address of the target. For example, to determine whether a

WAN port having the IP address of 10.100.100.1 on a remote router can

be reached from the router module, you would execute Ping as follows

from the NCL prompt:

ping 10.100.100.1

When a target is “pinged”, the router module waits for a response. In the

above example, if a response was received within the specified time, the

console would display this message:

10.100.100.1 is alive

To send an AppleTalk Echo Protocol (AEP) request message to a

specific AppleTalk node address, use the NCL Atping command.

For more information on Ping and Atping, refer to pages 4-12 and 4-13 in

this manual and to the Operator’s Reference.

Installation

4. Verify the Network Links.

2-18

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 103 104

Keine Kommentare

HP 10BASE-T Installationshandbuch Seite 51