HP 600N Installationshandbuch PDF herunterladen (Seite 37)

Control Panel Configuration 3-11

Control Panel

Configuration

Configuring Apple EtherTalk Phase

Parameters (Ethernet Cards Only)

You can configure Apple EtherTalk parameters if the Apple

EtherTalk protocol is enabled (ETALK=ON*), and the PostScript

printer language is enabled.

To ensure the PostScript printer language is enabled, check the

printer’s CONFIGURATION MENU. PERSONALTY=PS* or

PERSONALTY=AUTO* should be set.

To configure EtherTalk parameters

If you haven't already done so, enable EtherTalk by following the

instructions described in “To Enable or Disable Network Protocols”

in this chapter.

1. Take the printer offline by pressing [Go]. The “Ready” LED

should be off.

2. Press

[Menu] repeatedly until EIO # JETDIRECT MENU is displayed

(# identifies the EIO slot number of the card).

3. Press [Item] until CFG NETWORK=NO* appears.

NO* indicates that access to the EIO JetDirect network menus

will be bypassed. You must change this to CFG NETWORK=YES* to

access the EIO JetDirect menus:

a. Press [Value]. CFG NETWORK=YES appears.

b. Press [Select]. CFG NETWORK=YES* appears.

4. Press [Item] to scroll through each network protocol until

CFG ETALK=NO* is displayed.

To access the EtherTalk configuration menu, press [Value] and

then press [Select] to display CFG ETALK=YES*.

5. Press [Item]. ETALK PHASE=1* or ETALK PHASE=2* appears.

■

The asterisk (*) indicates the active phase setting.

■

To change the phase setting, press [Value] until the phase

setting that you desire appears, then press [Select]. Be sure

“*” appears alongside your selection.

6. To activate the printer and save your changes, press [Go].

S00eiohw.book Page 11 Thursday, February 24, 2000 2:26 PM

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 53 54

Keine Kommentare

HP 600N Installationshandbuch Seite 37