HP 600N Installationshandbuch PDF herunterladen (Seite 35)

Control Panel Configuration 3-9

Control Panel

Configuration

Note The card m u s t b e c onfigured with a v a l i d IP address

to operate on a TCP/IP network.

For DHCP (Dynamic Host Configuration Protocol)

operation, BOOTP must be enabled.

If an IP address is configured through DHCP and is

subsequently changed through the control panel,

the DHCP assigned address is released.

If a printer is configured through DHCP, and you

manually change the subnet mask or default

gateway through the control panel, you should

also change the IP address.

To configure TCP/IP parameters

If you have not already done so, enable TCP/IP (TCP/IP=ON*) by

following the instructions described in “To Enable or Disable

Network Protocols” earlier in this chapter.

Note Enter data carefully. If you make an incorrect entry,

you cannot change it without starting again from

step 1.

1. Take the printer offline by pressing [Go]. The “Ready” LED

should be off.

2. Press

[Menu] repeatedly until EIO # JETDIRECT MENU is displayed

(# identifies the EIO slot number of the card).

3. Press [Item] until CFG NETWORK=NO* appears.

NO* indicates that access to the EIO JetDirect network menus

will be bypassed. You must change this to CFG NETWORK=YES* to

access the EIO JetDirect menus:

a. Press [Value]. CFG NETWORK=YES appears.

b. Press [Select]. CFG NETWORK=YES* appears.

S00eiohw.book Page 9 Thursday, February 24, 2000 2:26 PM

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 53 54

Keine Kommentare

HP 600N Installationshandbuch Seite 35