HP Power PC Printer Bedienungsanleitung PDF herunterladen (Seite 10)

2. Set-up

2-1 Connecting the printer cable

CAUTION: ALWAYS turn the main switch to the printer OFF (O)

BEFORE connecting the printer cable.

Turn the main switch located on the right side of the printer

OFF (O) and then turn the power off to your computer as

well.

Remove the cover lacted at the back of the right side of the

printer, and connect the printer cable to the parallel interface

connector.

* If the optional Network Card is installed in the printer,

connect the printer cable (100BASE-TX, etc.) and perform

the appropriate network settings. Refer to “2-3 Network

(TCP/IP) settings” on page 4.

Connect the other end of the printer cable to the parallel

interface connector on your computer.

Turn the main switch to the printer back ON ( | ).

2-2 Installing the software

Perform the following procedure to install into your computer the

printer driver and other software that is appropriate to the operating

system in use in that computer. For information on installing the

required software, refer to the On-Line Manual that is located on the

CD-ROM that is included with this product.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 47 48

Keine Kommentare

HP Power PC Printer Bedienungsanleitung Seite 10