HP XM600 Bedienungsanleitung PDF herunterladen (Seite 6)

Installing and Replacing Hardware Parts in Your PC Workstation

Removing and Replacing a Processor

Single-processor systems can be upgraded to dual-processor systems by

installing a second processor in the vacant processor slot. The second

processor must be of the same type, speed and level-2 cache memory

capacity as the first.

1 Switch off the display and PC Workstation. Disconnect all power cables

and any LAN or telecommunications cables.

2 Remove the PC Workstation’s cover (refer to page 3 for instructions).

3 Remove the HP UltraFlow Airflow Guide (refer to page 5).

4 If you intend to:

a Remove a Processor:

Press the retention clips on both sides of the processor outwards.

Then gently lift the processor upwards from the processor

connector, taking care not to tilt it too much.

b Install a Second Processor:

Remove the processor terminator from the CPU 2 connector. Store

the terminator in a safe place. For information about upgrading the

operating system, refer to "HP DualExpress!", on page 7.

Chapter2.fm Page 6 Wednesday, December 8, 1999 6:13 PM

1 2 3 4 5 6 7 8 9 10 11 ... 40 41

Keine Kommentare

HP XM600 Bedienungsanleitung Seite 6