HP Vectra 486VL Betriebsanweisung PDF herunterladen (Seite 11)

MS9530 Voyager RF Base Station - 10 - Printed: September 2002

Version: 1.1 Status: Approved

Keyboard Wedge mode

The Base Station must be connected between the keyboard and the

terminal with the “Y” cables series.

The list of terminals supported with the required

cables is enclosed to this manual.

To install the Base Station in keyboard wedge

mode follow these steps:

1 - Turn off power to the terminal.

2 - Install the correct Base Station cables plugging the 8 pins

modular connector to the port labelled "interface".

3 - Disconnect the keyboard from the terminal and plug the

connectors of the Base Station cables in the keyboard and

display.

4 - Connect the power supply, if necessary. Power up the host.

The Base Station will beep and after a short delay, will

beep again.

5 - Type on the keyboard to verify that the Base Station is

transparent to the system.

6 - Now, the Base Station is ready to work or, if necessary, to

be configurated. Please read VoyagerRF Installation and

User Guide for details how to link Voyager RF to Base

Station.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 83 84

Keine Kommentare

HP Vectra 486VL Betriebsanweisung Seite 11