HP Pavilion DV3-2014 Bedienungsanleitung Seite 1

HP Pavilion DV3 Heatsink/Fan ReplacementThis is a guide to removing and replacing the heatsink and fan unit from the HP PavilionDV3.Written By: Brando

Step 17Locate and remove the three blackscrews beneath where the batterywas located.One screw is in the middle andthe other two are in the innercorne

Step 19 Locate the top trim piece, pull it up from the edges that are next to the keyboard, androtate it open and away from you as shown.Caution! T

Step 21 Grab the ribbon cable and slide it towards you, out of the black connector.Lift the keyboard up and set it to the side.Step 22 Locate th

Step 23 Locate the clip for the left ribbon cable attached to the top trim piece that was previouslylifted up. Repeat the process for the right ribb

Step 25 Locate the connector holding the black screen cable and pull the clear tab up to detach thecable.Pull the black cable out of the two clips ho

Step 26 Grab the bottom part of the palm rest and pull it up from the base of the laptop. Continue topull up around the piece until all the clips re

Step 28 Locate the small white connector holding red, white, and black cables and pull it to the leftto remove it from the clip.Pull the clip to th

Step 30Locate and remove the two blacklongscrews holding the CD drive.They will be 5 mm long and have a3.5 mm diameter head.Step 31 The motherboard

Step 32 Slide the CD drive to the right until it hits a stop.Hold the drive down and lift the motherboard up and away from the drive.Step 33 Loc

To reassemble your device, follow these instructions in reverse order.This document was last generated on 2015-05-05 12:53:41 PM.Step 34 Locate and

Step 1 — BatteryStep 1 – Battery: Locate thebattery release slider on the bottomof the laptop and move it in thedirection of the arrow to the unlockpo

Step 3 — Hard DriveLocate the screw for the hard drivecover (The cover has HPProtectSmart written on it).Remove the 3.5 mm diameter, 7mm long screw w

Step 5 With your fingers, grab the clear tab.Pull right first, and then upwards (towards you).The hard drive should slide out of place and detach

Step 7 Grab one of the edges to the cover and lift up (towards you).Set the cover to the side.The wireless card will now be exposed.Step 8 Using

Step 9 Locate the two black screws connecting the wireless card to the laptop. They will have a3.5 mm diameter head and be 4mm long. Remove the screws

Step 11 — RAM Remove the two 3.5 mm diameter head and 7 mm long screws using the Philips PH1screwdriver.Both screws will remain attached to the cov

Step 13 Using one hand, pull the RAM up and to the left to remove it.Step 14If there is a second RAM modulepresent (as shown), repeat steps 2and 3 to

Step 15 — Heatsink/FanLocate and remove all 12 blackscrews on the back cover. Theyhave a 3.5 mm diameter head andare 13 mm in length.Step 16Locate an