HP Integrity BL860c Spezifikationen PDF herunterladen (Seite 112)

1. Slide the server blade back into the enclosure until flush with the enclosure.

2. Close the lever.

NOTE: After you install the server blade back into the enclosure, the server blade might go

to standby power (Internal health LED is amber), or full power (internal health LED is green,

and the fans may get louder).

3. If the server blade does not come up to full power, push the Power button to get the server to

full power.

The fans might get louder as the server powers up to full power.

Removing and Replacing the Server Blade Access Panel

The access panel is located on the right side of the server blade (when mounted in an enclosure).

Removing the Server Blade Access Panel

To remove the access panel:

1. Power off the server blade and remove it from the server blade enclosure.

See “Preparing the Server Blade for Servicing” (page 110).

2. Unlock the cam on the access panel latch (if necessary) by turning the lock on the latch

counterclockwise with a 2.5 mm allen wrench.

3. Pull up on the access panel latch (1).

This causes the access panel to slide back about 1.75 cm (0.75 in).Figure 38.

4. Remove the access panel by lifting it straight up and off the server blade (2).

Figure 38 Removing the Server Blade Access Panel

Replacing the Server Blade Access Panel

To replace the access panel:

112 Removing and Replacing Components

1 2 ... 107 108 109 110 111 112 113 114 115 116 117 ... 183 184

Keine Kommentare

HP Integrity BL860c Spezifikationen Seite 112