HP Computer Technical Information PDF herunterladen (Seite 89)

4. Detach the connector board ribbon cable (5) from the base enclosure. (The connector board

ribbon cable is attached to the top cover with double-sided tape.)

5. Remove the three Phillips PM2.0×2.9 screws (1) that secure the connector board to the

top cover.

6. Lift the right side of the connector board (2) until it rests at an angle.

7. Remove the connector board (3) by sliding it up and to the right at an angle.

Reverse this procedure to install the connector board.

Component replacement procedures 79

1 2 ... 84 85 86 87 88 89 90 91 92 93 94 ... 130 131

Keine Kommentare

HP Computer Technical Information Seite 89