HP C200 Bedienungsanleitung PDF herunterladen (Seite 12)

Capstone Turbine Corporation  21211 Nordhoff Street  Chatsworth  CA 91311  USA

Product Specification: Model C200 - Capstone MicroTurbine

460045 Rev C (November 2008) Page 12 of 16

Capstone reserves the right to change or modify, without notice, the design, specifications, and/or contents of this document

without incurring any obligation either with respect to equipment previously sold or in the process of construction.

Air Flow Requirements at Full Load Power

Table 7 summarizes the nominal air flow requirements of the C200 MicroTurbine systems.

Table 7. Air Flow Requirements at ISO Conditions with Zero Back Pressure

Parameter All C200

Engine Inlet Air Flow

2,600 scfm

(73,600 slpm)

Engine Inlet Air Temp

(1) (2)

-20 to 50 °C

(-4 to 122 °F)

Electronics Controller Inlet Air Flow

(3)

3,600 scfm

(102,000 slpm)

Electronics Controller Inlet Air Temp

(2)

-20 to 50 °C

(-4 to 122 °F)

Notes:

(1) For C200 versions that include the external heat recovery module, minimum operating ambient temperature

may be higher, depending on heat recovery fluid characteristics. For water, minimum ambient temperature is 1.7 °C

(35 °F).

(2) The Electronics Controller inlet air temperature must be within 2 °C (3.6 °F) of the Engine inlet air temperature.

(3) Values are the same for all C200 configurations, including low pressure and dual mode versions with batteries.

1 2 ... 7 8 9 10 11 12 13 14 15 16

Keine Kommentare

HP C200 Bedienungsanleitung Seite 12