HP Apollo 9000 400t Wartungshandbuch PDF herunterladen (Seite 75)

. The Model 735 processor board has 16—MB main memory resident (unre-

movable). Therefore. the upgraded systemwill have 16MB more main

memory than the original system.

. The SIMMS mustbe installed as pairs (two cards of the same capacity).

. The Model 735 has sixpairs of slots (numbered 1 through 6).

. The slot pairs on the Model 735 processor board are arranged in two connec-

tor blocks, labeled H(igh) and L(ow). The pair numbering starts in the middle

of the board, one in each connector block.

● You load the boards left to right when the board is positioned as shown in

Chapter 3. Startwith the highest number H slot that will be occupied when

installingthe memory cards in the new processor board (if you are installing

four pan-sof cards, slot 4H isthe highest number H slot). You must then fill

the lower number slots in the H block. You then fill the lower numbers in

the L block, working toward the highest number L slot thatwill be filled.

. If you later need to add more SIMM cards, you will need to remove the cards

already installed in the H block, and startinstallingthe cards at the highest

number slot to be used. The cards already installed in the L block may re-

main installed; just add the new cards to the higher numbered slots. Be sure

that the SIMMS remain paired properly (two cards of the same capacity oc-

cupying the salineslot number in the H and L blocks) when you add new

cards.

Field Replaceable Units 5–15

1 2 ... 70 71 72 73 74 75 76 77 78 79 80 ... 86 87

Keine Kommentare

HP Apollo 9000 400t Wartungshandbuch Seite 75