HP 100Base-TX Bedienungsanleitung PDF herunterladen (Seite 30)

30 Chapter4

Troubleshooting SCSI

Troubleshooting

SCSI Command

Use the SCSI command to ensure SCSI controller and SCSI device compatibility by

displaying and selecting SCSI bus parameters.

The SCSI command is available from the boot menu displayed after the test station

has booted, provided autoboot is disabled.

The SCSI parameters can be displayed and modiﬁed using the SCSI command. The

syntax for this command is:

SCSI rate bus# slot# rate

SCSI init bus# slot# id#

Display and Set SCSI Transfer Rates

1. Display the SCSI transfer rate for an adapter using the SCSI command.

The following example lists the SCSI transfer rate for an adapter on bus 5 slot

command: SCSI rate 5 2

PCI device /5.2 = no limit

Enter the command without specifying a bus or slot number to list transfer rates

for all bus and slot numbers:

command: SCSI rate

2. Set the SCSI transfer rate for an adapter using the SCSI command.

The following example sets the adapter on bus 5 slot 2 to Fast SCSI and then

displays the results:

command: SCSI rate 5 2 10

bus# The bus number

slot# The adapter’s slot number

rate The adapter’s transfer rate

0: no limit

10: Fast SCSI

20: Ultra SCSI

id# The SCSI ID number of the adapter

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 119 120

Keine Kommentare

HP 100Base-TX Bedienungsanleitung Seite 30