HP ProCurve 800 Network Access Controller series Installationshandbuch PDF herunterladen (Seite 16)

2-8

Quick Install

Installing the Appliance

Quick Install

Horizontal Surface Mounting

Place the ProCurve NAC 800 on a table or other horizontal surface. The unit

comes with rubber feet in the accessory kit that can be used to help keep it

from sliding on the surface.

Attach the rubber feet to the four corners on the botto

m of the box within the

embossed angled lines. Use a sturdy surface in an uncluttered area. You may

want to secure the networking cables and switch power cord to the table leg

or other part of the surface structure to help prevent tripping over the cords.

Caution Make sure the air flow is not restricted around the sides and back of the unit.

3. Connect the Unit to a Power Source

1. Plug the included power cord into the ProCurve NAC 800’s power

connector and into a nearby AC power source.

Figure 5. ProCurve NAC 800, rear view with power plug

Connect power cord

to power connector

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 43 44

Keine Kommentare

HP ProCurve 800 Network Access Controller series Installationshandbuch Seite 16