HP Embedded Firewall Series Bedienungsanleitung PDF herunterladen (Seite 56)

11 Configuring the NIC

3 Reboot the computer.

The MBA attempts to boot from the network using the default boot method PXE. To

change the default boot method or any other MBA configurations, press Ctrl+Alt+B

when the following message appears:

Initializing MBA. Press Ctrl+Alt+B to configure...

If the network boot fails, the following message appears:

Network boot aborted, press any key to continue

The BIOS continues to the next device in the boot order (for example, the local hard

drive).

Non-BBS BIOS-Compatible PCs

To enable a non-BBS BIOS-compatible computer to boot from the network using the MBA

boot ROM:

1 Make sure that the NIC boot ROM setting is Enabled.

See “Enabling or Disabling the Boot ROM Setting” on page 49 for instructions.

2 Change the MBA default boot setting from Local to Network.

To change the default boot setting or any other MBA configurations, use the

MBACFG utility or press Ctrl+Alt+B when the following message appears:

Initializing MBA. Press Ctrl+Alt+B to configure...

Disabling the 3Com Logo

To disable the 3Com logo that appears during startup:

1 Make sure that the NIC, the network driver, and the 3Com NIC Diagnostics program

are installed.

2 Open the Windows Start menu.

3 Select Programs, and then 3Com NIC Utilities.

4 Click 3Com NIC Doctor.

The 3Com NIC Diagnostics General screen appears.

5 On the General screen, make sure that the check box next to Show 3Com Logo on

Startup is not selected.

6 Exit the 3Com NIC Diagnostics program.

NOTE: To cancel the network boot, press Esc anytime during the network boot

process.

NOTE: For more information on using, configuring, and troubleshooting the MBA

boot ROM, refer to the Managed PC Boot Agent User Guide, located with the

MBA software on the 3Com Installation CD.

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 85 86

Keine Kommentare

HP Embedded Firewall Series Bedienungsanleitung Seite 56