HP AdvanceStack Router 230 Installationshandbuch PDF herunterladen (Seite 23)

1. Ensure that the LAN cable is properly grounded. (Refer to ‘‘Safety

Information’’ in the back of this manual.)

2. Attach a ThinLAN cable section to one side of a BNC ‘‘T’’ connector.

3. Attach another ThinLAN cable section or a 50-ohm terminator to the

other side of the ‘‘T’’ connector.

Note Each coaxial cable segment must be terminated with a 50-ohm

terminator at each end. Figure 1-13 shows the ThinLAN port at the end

of a cable segment, with the 50-ohm terminator attached to one side of

the BNC ‘‘T’’ connector.

4. Attach the “T” connector to the BNC port on the router.

5. Fold the BNC ‘‘T’’ connector cover around the connection and

squeeze the surfaces together around the edges.

Figure 1-14.The Installed BNC Connector Cover

Figure 1-12.BNC Connector -- Mid-Cable Figure 1-13.BNC Connector -- End-of-Cable

Installation

Phase 3: Prepare the Router Hardware

1-15

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 143 144

Keine Kommentare

HP AdvanceStack Router 230 Installationshandbuch Seite 23