HP J3188A Bedienungsanleitung PDF herunterladen (Seite 33)

3-3

Managing the Hub

Setting up the ASCII Console

Managing the Hub

Remotely, Using a Modem and a Terminal

1. Use a full-duplex, asynchronous (character-mode) modem only.

2. Connect the modem to the hub’s RS-232 port using an RS-232-C modem

cable. (For pin-outs and recommended cables see Appendix A, “Cables

and Connectors”.)

3. Configure the modem as described in the Appendix C, “Modem

Configuration.”

4. At the remote site, connect the terminal (or PC emulating a terminal) to

the remote modem. Make sure the terminal and modems are functioning

properly, then establish the link between the terminal’s modem and the

hub’s modem according to the modem instructions.

5. Press [Enter] several times for the => or Password prompt. The baud rate

for communication between the hub and the modem is set automatically

when you press [Enter].

Starting the Console

The console session starts with a display similar to the following (the actual

version numbers may be different):

HP J3188A Hub-16M

ROM A.01.00

EEPROM A.01.00

HW A.01.00

Use console commands for hub configuration.

Enter password:

If a password has not been assigned with the PAssword command, then you

are not prompted for your password here.

If a console session is currently active, then you are prompted to break the

current active console session.

A console session is currently active.

Do you want to break in? (Y/[N]) Y

Connecting…

Enter a console command, or HE or? for help.

MUCHO.BK : ch3.fm5 Page 3 Thursday, June 26, 1997 11:37 AM

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 99 100

Keine Kommentare

HP J3188A Bedienungsanleitung Seite 33