HP 100BaseT Betriebsanweisung PDF herunterladen (Seite 66)

HP 100Base-T Hubs Installation and Reference Guide

Configuring the System 4-7

Using the VT-100 Console Interface

The Hub-12TX, Hub-12TXM and Hub-24TX all provide a

menu-driven VT-100 console interface. The VT-100 console

interface differs for the Hub-24TX, Hub-12TX and the Hub-

12TXM. The connection types allowed and options provided

are summarized below:

• The Hub-24TX is designed as a manageable hub, without an

on-board SNMP agent. Therefore, when an SNMP agent

(i.e., the Hub-12TXM) is connected to this hub via the

Stacking Cable, its Console Port will be disabled, and

configuration must be carried out using the Hub-12TXM.

However, if this hub is not connected to an agent, you can

configure it by making a direct connection to the Console

Port.

• The Hub-12TX is also designed as a manageable hub,

without an on-board SNMP agent. Like the Hub-24TX, it

can be configured by being connected to a Hub-12TXM in a

stack, or if there is no agent, by a direct connection to the

Console Port.

• When configuring a Hub-12TXM and connected stack, you

can use a direct connection to the Console Port, use a Telnet

connection from a networked computer, or use a standard

modem connection from a remote computer.

System Configuration for the Hub-24TX

With the VT-100 console interface you can carry out basic

configuration on the attached hub, such as setting the hub ID or

isolating the hub from the stack. Set up a direct connection to

the hub, press the Enter key several times, and enter the

password (or just press the Enter key if you have not yet

configured the password). The following menu will be

displayed after logging on.

1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 156 157

Keine Kommentare

HP 100BaseT Betriebsanweisung Seite 66