HP 10BASE-T Betriebsanweisung PDF herunterladen (Seite 39)

Port status LEDs

The following table provides LED port status information. If an

AdvanceStack 8U/16U SNMP module is installed, additional LED states may

be observed. For information about the hub LEDs when a module is

installed, see the manual accompanying the module.

LED State Meaning of LED

AUI/Xcvr

Port (green)

On An optional HP Transceiver Module is properly installed in the

hub’s back panel slot.

Off An HP Transceiver Module is not installed.

Slow

Flash*

The HP Transceiver Module port has auto-partitioned. See

“Auto-Partitioning” later in this chapter.

Twisted-pair

Port (green)

On Link beat is detected from the attached node.

Off The port is not receiving the link beat signal from the attached

node.

Slow

Flash*

The port has been auto-partitioned. See “Auto-Partitioning”

later in this chapter.

* The slow flash is approximately once every 1.5 seconds.

Hub Reference

3-3

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 66 67

Keine Kommentare

HP 10BASE-T Betriebsanweisung Seite 39