HP TippingPoint Next Generation Firewall Series Installationshandbuch PDF herunterladen (Seite 46)

34 Power Supply and Fan Modules

WARNING! Do not attempt to install a DC power supply into an NGFW Appliance. The NGFW

Appliance does not contain the grounding capability for safe installation of a DC power supply. Bodily

harm and damage to the system could result.

When the AC power supply has been securely placed in the appliance, use the following procedure to

connect power to the AC power supply:

1. Locate the male power input on the back of the chassis.

2. Plug one end of a standard female power plug into the power input.

3. Plug the other end into an AC outlet, power strip, or UPS. The power should meet the following

requirements:

• Voltage: 100 – 240 VAC

•Current: 12 – 6 Amps

• Frequency: 47 – 63 Hz

4. The NGFW Appliance returns to its previous power-on state in the event of a power interruption. If

power was on when the interruption occurred, the appliance automatically powers back on when the

power is reconnected; if power was off, the appliance stays off when the power is reconnected. If

necessary, power on the appliance with the button on the front of the chassis.

Replacement power supplies are shipped with replacement instructions. Refer to that document when

replacing a faulty power supply.

NGFW Fans

The NGFW Appliances include three cooling fans. The fans for the NGFW S3000/S8000 Series

appliances are redundant and hot-pluggable, and can be replaced without powering down the appliance.

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 52 53 54

Keine Kommentare

HP TippingPoint Next Generation Firewall Series Installationshandbuch Seite 46