Hp ZR30w Bedienungsanleitung PDF herunterladen (Seite 18)

Mounting the Monitor

NOTE: This apparatus is intended to be supported by UL or CSA Listed wall mount bracket.

The HP Quick Release can be removed from the pedestal base and installed to a mounting fixture. It

allows you to quickly and securely attach the monitor panel to the mounting fixture.

1. Remove the monitor panel from the pedestal base. Refer to

Removing the Monitor Pedestal

Base on page 11 in the previous section.

CAUTION: This monitor supports the VESA industry standard 100 mm mounting holes. To attach

a third-party mounting solution to the monitor, four 4 mm, 0.7 pitch, and 10 mm long screws are

required (not provided with the monitor). Longer screws must not be used because they may

damage the monitor. It is important to verify that the manufacturer’s mounting solution is compliant

with the VESA standard and is rated to support the weight of the monitor display panel. For best

performance, it is important to use the power and video cables provided with the monitor.

2. Remove the Quick Release from the pedestal base by removing the four screws.

Figure 3-11 Removing the HP Quick Release from the Pedestal Base

12 Chapter 3 Setting Up the Monitor ENWW

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 33 34

Keine Kommentare

Hp ZR30w Bedienungsanleitung Seite 18