HP 132A Bedienungsanleitung PDF herunterladen (Seite 189)

Chapter 4 Command Reference

Introduction

Programming Guide 4-23

• If the current measurement is Totalize or Voltage Peaks, Not a Number

9.91E37 is returned and error -221 is generated.

• Query only.

• The last calculated result remains valid until a new computation is made or a

relevant instrument state is modified.

:CALCulate3:FEED “[:]CALCulate[1]”

Sets or queries the data flow to be fed into the CALCulate3 block.

The string “CALC” is returned.

*RST: “CALCulate[1]”

:CALCulate3:LFILter Subtree

This subtree collects together the commands used to specify which measurements

will be used in computing statistics; out-of-limit measurements can be filtered out

of the statistics processing.

Not until :CALCulate3:LFILter:STATe is set to ON will any of the

:CALCulate3:LFILter settings be used.

:CALCulate3:LFILter:LOWer[:DATA] <numeric_value> [HZ | S

|DEG]

Sets or queries the statistics filter lower limit.

If limit filtering is enabled (:CALC3:LFIL:STAT ON), any measurements below

this value will not be combined into the statistics computation.

If math is enabled (:CALC:MATH:STATe ON), the limit value specified should

take into account that the filtering is on measurements that have been scaled and

offset.

-9.9999990000E+12 to -1.0000000000E-13, 0.0000000000, +1.0000000000E-

13 to +9.9999990000E+12.

11 digits

Comments

Query Response

Comments

NOTE

<numeric_value>

Range

<numeric_value>

Resolution

1 2 ... 184 185 186 187 188 189 190 191 192 193 194 ... 329 330

Keine Kommentare

HP 132A Bedienungsanleitung Seite 189