HP tm2-2102tu Technical Information PDF herunterladen (Seite 68)

●

Fan (see

Fan on page 63)

●

Heat sink (see

Heat sink on page 64)

Remove the system board:

1. Disconnect the Bluetooth module cable (1) from the system board.

2. Release the ZIF connector to which the power switch board cable is connected, and disconnect the

power switch board cable (2) from the system board.

3. Remove the four Phillips PM2.5×4.0 screws (1) that secure the system board to the base

enclosure.

4. Remove the two Phillips PM2.5×4.0 screws (2) that secure the power connector to the base

enclosure.

5. Release the power connector (3) from the base enclosure.

Use the hard drive connector (1) to lift the right side of the system board (2) until it rests at an

angle.

60 Chapter 4 Removal and replacement procedures ENWW

1 2 ... 63 64 65 66 67 68 69 70 71 72 73 ... 108 109

Keine Kommentare

HP tm2-2102tu Technical Information Seite 68