Hp DC5000 Bedienungsanleitung PDF herunterladen (Seite 44)

B–2 www.hp.com Hardware Reference Guide

PATA Hard Drive Installation Guidelines

❏ 18 inches maximum total length, 80-conductor cable with

maximum spacing of 6 inches between Device 0 and

Device 1.

80-Conductor PATA Cable

■

For optimal performance, connect hard drives to the primary

controller. Connect expansion devices, such as ATA optical drives

and tape drives, to the secondary controller.

■ Install either a third-height or a half-height drive into a

half-height bay.

■ Install guide screws to ensure that the drive lines up correctly in

the drive cage. Hard drives use 6-32 standard guide screws. Four

extra guide screws are installed on the hard drive bracket under

the access panel. HP-supplied standard screws are silver.

■ If only one device is connected to a cable, that device must be

attached to the end (Device 0) connector.

✎

If you have only one device, make sure to connect it to the Device 0

connector. If you connect it to the Device 1 connector, the system will

not recognize the device and you may receive a “no fixed disk found”

error message.

1 Device 0 (primary drive) connector

2 Device 1 (secondary drive) connector

3 System board connector

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 68 69

Keine Kommentare

Hp DC5000 Bedienungsanleitung Seite 44