HP sa8250 Schnellstart Anleitung PDF herunterladen (Seite 13)

Running Setup using the Boot Monitor

6. Login to the SA8250, using the factory defaults:

password:admin

NOTE: Access is

controlled using Access

Control Lists. For more

information, see Chapter

5 in the User Guide.

7. To permit all administration tasks to be performed without

restriction from all IP addresses and to enable IP forwarding,

type the following command:

HP SA8250#config sys security mode open

After the initial configuration, you do not need to access the Boot

Monitor again unless your network configuration changes.

While the SA8250 is booting, the front panel LEDs display a

characteristic start pattern. After the boot sequence concludes, the

Power LED is solid and the Status LED blinks. If you observe any

deviation from this behavior, see Appendix E in the User Guide. The

SA8250 normally requires approximately two minutes to boot.

When the procedure is complete, the monitor prompt appears (if

Autoboot is disabled).

Requirements

for DHCP

(Optional)

DHCP provides a method by which devices using TCP/IP can obtain

configuration parameters automatically through the network at

restart. If you use DHCP, you must provide the DHCP server with

the following parameters for it to pass to the SA8250:

• IP address

NOTE: DHCP is not

available during dual

NIC operations, or when

Serial Cable Failover is

enabled.

• Netmask

• Default gateway

• Host Name (the SA8250’s name)

• Domain (optional)

• Domain Name Server (optional)

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 21 22

Keine Kommentare

HP sa8250 Schnellstart Anleitung Seite 13