HP D2D2502i Betriebsanweisung PDF herunterladen (Seite 60)

• netmask – This optional parameter defines the netmask. If the IPAddr value is DHCP, a value

is not required for netmask.

• gateway – This optional parameter defines the gateway for the subnet configuration.

• ports – This parameter defines the ports which will be attached to the subnet for each node

associated with the network configuration containing the subnet. (See the “net activate config”

(page 55) command for details on how the nodes are associated with network configurations.)

The values consist of a list of integers separated by commas; the integers define the physical

ports on the nodes. Execute the “net show ports” (page 78) command to obtain information

on which integers may be used to define ports for the subnet configuration. The maximum

number of values depends on your system; use the Command Authority (page 56) command

for information on which ports are available.

Requirements for Command Execution

• The command entry must conform to the command syntax.

• All object values must be valid; see the object descriptions for details.

• All parameter values must be valid; see the parameter descriptions for details.

Successful Command Output

Upon successful completion of the command, information on the external network configuration is

displayed.

Command Operation during Abnormal Conditions

If the command does not conform to the required syntax, the following is displayed:

Command Failed - the command does not conform to the required syntax,

SYNTAX, where SYNTAX is the command syntax as described under Command Syntax in this

section.

Example

# net create config management dns dhcp

60 Alphabetical List of Commands and Details

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 177 178

Keine Kommentare

HP D2D2502i Betriebsanweisung Seite 60