Hp Media Center m270 Desktop PC Bedienungsanleitung PDF herunterladen (Seite 62)

Removing and replacing the diskette drive

or the 6-In-1 memory card reader

To ensure that the drive fits properly into the chassis,

be sure to purchase the replacement drive from HP.

1 Remove the drive cage. (See page 52.)

2 Remove the two screws that secure the diskette drive

in the drive cage: one screw on each side of the

drive cage. (The screws for the 6-In-1 memory card

reader were removed when the drive cage was

removed.)

3 Pull the drive out of the drive cage. Slide the

replacement drive into the drive cage.

4 For the diskette drive, attach the screws: one on

each side of the drive cage. (The screws for the

6-In-1 memory card reader are replaced when the

drive cage is replaced.)

5 Replace the drive cage. (See page 53.)

Removing and replacing the

preinstalled hard drive

You must remove the hard drive from the chassis if you

want to replace it with a higher capacity drive or if you

want to safeguard your data when sending the computer

out to be repaired.

1 Remove the drive cage. (See page 52.)

2 Remove the three screws that secure the hard drive

in the drive cage: two screws on the latch side of the

drive cage and one screw on the opposite side.

3 Pull the hard drive out, and store the drive and screws

in a safe location.

4 To replace the hard drive, reverse these steps. Make

sure the jumper on the new hard drive is in the CS

(Cable Select) position. (See figure on page 51).

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 81 82

Keine Kommentare

Hp Media Center m270 Desktop PC Bedienungsanleitung Seite 62