Hp Netserver L Server series Bedienungsanleitung PDF herunterladen (Seite 36)

Chapter 3 Opening and Closing the

HP NetServer

3. Remove the HP NetServer's rear access panel:

a. Loosen the three captive screws that fix the panel in place. See Figure

3-10.

b. Lift off the panel.

Mounting Tab

Captive

Screws

Figure 3-10. Removing the Rear Access Panel

4. The lower board cage is now exposed. Remove or add boards as needed,

then reattach the rear access panel:

a. Lower the panel into place. A slotted flange extends from the top of

the panel on either side. You must align the slots with the matching

tabs on the satellite chassis. See Figure 3-10.

b. Tighten the three captive fasteners.

5. Reattach the lower fan module:

a. On each side of the back of the fan module are two slots. Line these

slots up with the flanges on the fan's mounting rails. See Figure 3-9.

b. Push the fan module onto the mounting rails until the module clicks

into place.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 146 147

Keine Kommentare

Hp Netserver L Server series Bedienungsanleitung Seite 36