Hp Netserver L Server series Bedienungsanleitung PDF herunterladen (Seite 16)

Chapter 2 Controls, Ports, and Indicators

• In Europe:

◊ For a single NetServer in a rack, use a 15-amp-minimum circuit with

one IEC MCB C-type breaker for each 16-amp PDU.

◊ For multiple NetServers in a rack, use a 15-amp-minimum circuit with

one IEC MCB D-type breaker for each 16-amp power distribution

unit.

Each 16-amp PDU can accommodate a maximum of two NetServers.

When the proper power supply is available, connect the NetServer to the AC

power source.

Power-On Tests

The NetServer runs a set of diagnostic tests when it is first connected to a power

source. If the NetServer passes the tests, you will see:

HP NetServer

LH 3

If the NetServer does not pass the tests, you will see:

Display now?

Press Enter to view the error message. Write the error message down and refer to

"POST Codes" in Chapter 12, "Troubleshooting."

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 153 154

Keine Kommentare

Hp Netserver L Server series Bedienungsanleitung Seite 16