Hp Netserver L Server series Bedienungsanleitung PDF herunterladen (Seite 17)

Chapter 1 Installation Overview

e. Configuration Advisor displays the Configuration Advisories. You can

print them out by saving them to disk (diskette) and later printing out

from the diskette.

Read the documentation supplied with the accessory boards. If you are installing

an fSA non-Plug-and-Play board, write down the switch andjumper settings and

all system resource requirements (such as memory range, I/O port range, DMA

channel, and IRQ level). Refer to these notes when you allocate system resources

to the fSA non-Plug-and-Play board when you configure the HP NetServer.

Install Additional Mass Storage Devices

Certain mass storage configurations may require additional cables or adapters. For

part numbers for HP cables, adapters, and trays, and configuration information,

see Information Assistant on the HP Navigator CD-ROM. For new products, you

can use Order Assistant on the HP Web Site at http://www.hp.com/go/netserver.

Replace All Covers and Connect All Cables

Refer to Figure 1-6 and replace all covers.

CAUTION Replace ALL covers before operating the HP NetServer, even

for a short time. Otherwise, overheating can damage

processors, boards, and mass storage devices.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 111 112

Keine Kommentare

Hp Netserver L Server series Bedienungsanleitung Seite 17