Hp Smart Array P430 Controller Bedienungsanleitung PDF herunterladen (Seite 13)

Installation and configuration 13

Installation and configuration

Procedures for controllers in a server

To install a stand-up controller in a server, choose one of the following procedures:

• Installing a stand-up controller in an unconfigured server (on page 13)

• Installing a stand-up controller in a previously configured server (on page 13)

Installing a stand-up controller in an unconfigured server

IMPORTANT: Do not power up the server until the hardware configuration is satisfactory, as

described in the procedure given in this section.

To install the controller in an unconfigured server:

1. Install the controller hardware ("Installing the controller board" on page 14). For server-specific

procedures, see the server user guide.

2. If the controller supports external storage, connect external storage devices to the controller.

3. Install physical drives, as needed.

4. Power up the external storage devices.

5. Power up the server.

6. Verify the server firmware is the latest revision. If necessary, update the server firmware ("Updating

firmware" on page 20).

7. Verify the controller firmware is the latest revision. If necessary, update the controller firmware

("Updating firmware" on page 20).

8. Verify the drive firmware is the latest revision. If necessary, update the drive firmware ("Updating

firmware" on page 20).

9. Verify the iLO firmware is the latest revision. If necessary, update the iLO firmware ("Updating

firmware" on page 20).

10. If expanders are present, verify the expander firmware is the latest revision. If necessary, update the

expander firmware ("Updating firmware" on page 20).

11. Install the operating system and device drivers ("Installing device drivers" on page 20). Instructions are

provided with the CD that is supplied in the controller kit.

12. (Optional) Create additional logical drives ("Configuring an array" on page 20).

The server is now ready for use.

Installing a stand-up controller in a previously configured server

1. Back up data on the system.

2. Close all applications.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 45 46

Keine Kommentare

Hp Smart Array P430 Controller Bedienungsanleitung Seite 13