Hp Parallel Uninterruptible Power System Bedienungsanleitung Seite 104
- Seite / 115
- Inhaltsverzeichnis
- FEHLERBEHEBUNG
- LESEZEICHEN
Bewertet. / 5. Basierend auf Kundenbewertungen
Specifications 104
Feature Specification
Relative humidity
Operating: 5% to 95%; noncondensing
Non-operating: 5% to 95%; 38.7°C (101.7°F)
maximum wet bulb temperature with no cosmetic
damage
Operating altitude
Up to 1,000 m (3,300 ft) above sea level
Up to 2,000 m (6,600 ft) with 1% derating per + 100 m
(330 ft)
Transit altitude
UP to 15,000 m (49,000 ft) above sea level
Heat dissipation
1432 BTU/hr maximum at 100% rated load (High
Efficiency Mode)
4094 BTU/hr maximum at 100% rated load (Standard
Mode)
Audible noise
Less than 58 dBA at 1 meter typical (Normal Mode)
Less than 64 dBA at 1 meter typical (Battery Mode)
Leakage current
<3.5 mA
Surge suppression
ANSI C62.41 Category B3
Safety conformance
3 Phase UPS NA: UL 1778 4th edition; CSA C22.2,
No. 107.1 and No. 107.3
3 Phase UPS INTL: EN 60950-1 and IEC 62040-1-1
Agency Markings
3 Phase UPS NA: UL/cUL
3 Phase UPS INTL: CB, CE, GS, Ctick, GOST, BSMI
EMC (Class A)
3 Phase UPS NA: FCC Part 15, ICES
3 Phase UPS INTL: EN 62040-2
Battery specifications
Feature Specification
Configuration
UPS internal batteries: (40) 12 V, 5 Ah
+1 ERM: (20) 12 V, 9 Ah
+2 ERMs: (40) 12 V, 9 Ah
+3 ERMs: (60) 12 V, 9 Ah
+4 ERMs: (80) 12 V, 9 Ah
Type
Each model contains maintenance-free, sealed,
valve-regulated lead-acid batteries.
Monitoring
Advanced monitoring for earlier failure detection and
warning
Charging
8-10 times the discharge time. Complete charge takes no
more than 48 hours. Approximately 5 hours to 80 percent
capacity at default nominal utility voltage and no load.
Battery runtimes
Battery runtimes are approximate and vary depending on the load configuration and battery charge.
- HP 3 Phase UPS 1
- User Guide 1
- Contents 3
- Contents 4 4
- Contents 5 5
- Contents 6 6
- Component identification 7
- UPS front panel 8
- UPS front panel controls 9
- UPS rear panel 10
- ERM rear panel 12
- UPS installation 13
- Selecting a site 14
- Readying the equipment 14
- UPS installation 15 15
- UPS installation 16 16
- Installing the UPS 17
- Installing the batteries 19
- UPS installation 20 20
- Connecting the REPO port 21
- • For the 12kVA models— 24
- Charging the UPS batteries 25
- • 50/60 Hz 26
- Bottom entry 27
- Wiring the terminal block 28
- UPS installation 31 31
- UPS installation 32 32
- UPS installation 34 34
- UPS installation 36 36
- UPS installation 37 37
- Item Description 42
- UPS installation 44 44
- UPS installation 46 46
- UPS installation 47 47
- UPS installation 49 49
- UPS installation 51 51
- UPS installation 52 52
- ERM installation 55
- ERM installation 57 57
- ERM installation 59 59
- Installing the ERM 60
- ERM installation 62 62
- Charging the ERM batteries 63
- UPS operations 64
- Normal mode 65
- Battery mode 66
- Auto-Bypass mode 66
- Configuring the UPS 67
- Changing user settings 68
- Silencing an audible alarm 71
- Communication 74
- Communication options 75
- Control terminals 76
- Relay output contacts 76
- Programmable signal inputs 77
- Parallel communication 77
- Mode transfers 78
- Redundant signal wiring 78
- Auto-identification 78
- Metering 79
- Power management 80
- Maintenance 81
- Replacing UPS X-Slot cards 83
- Replacing the batteries 87
- Replacing the UPS 89
- Replacing the ERM 90
- Updating the UPS firmware 91
- Click Action 93
- The Action Menu appears 93
- Troubleshooting 94
- Battery breaker 95
- Battery connection condition 96
- Battery low condition 96
- Battery test condition 96
- Bypass is unavailable 96
- Phase rotation verification 97
- Overload condition 98
- Overtemperature condition 98
- Selective trip 99
- Site wiring condition 99
- UPS does not power down 99
- UPS does not power up 99
- UPS is on battery 100
- UPS is on bypass 100
- Specifications 101
- UPS input specifications 102
- UPS output specifications 103
- Environmental specifications 103
- Battery specifications 104
- Battery runtimes 104
- REPO port specifications 105
- Ordering spares 106
- UPS spare parts list 106
- Hardware options 106
- Support and other resources 107
- Regulatory information 108
- Pre-Failure Battery Warranty 109
- Electrostatic discharge 110
- Acronyms and abbreviations 111
- Documentation feedback 112
- Index 113 113
- Index 114 114
- Index 115 115
Verwandte Produkte und Handbücher für Computerzubehör Hp Parallel Uninterruptible Power System
(14 Seiten)
(29 Seiten)© 2020, manymanuals.de. Alle Rechte vorbehalten. | 0.056 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern