HP 80ex Bedienungsanleitung PDF herunterladen (Seite 50)

3-18 Chapter 3

Operating the Jukebox

Changing SCSI IDs

The jukebox controller uses two SCSI IDs if your jukebox has one drive and three

IDs if your jukebox has two drives. The jukebox controller is assigned one ID and

one ID is assigned to each disk drive.

The default SCSI IDs are as follows

• jukebox controller = 3

• disk drive 1 (lower drive) = 4

• disk drive 2 (upper drive in a two-drive model) = 5

If you are already using one of these IDs for your computer or another SCSI

peripheral device, follow the directions in one of the next two sections to change

either the jukebox controller or a drive ID.

Changing the Jukebox Controller ID

Start with READY in the display.

1. Press

NEXT until SCSI ID * displays.

2. Press

ENTER. AC ID * displays. (“AC” is the “jukebox controller.”)

3. Press

ENTER. AC ID 3 displays.

4. Press

NEXT or PREV until the ID you want displays.

5. Press

ENTER. SET # (# is a number from 0-7) displays briefly and then AC ID

* displays again. The ID you chose is now set.

6. Press

CANCEL two times to return to the READY state.

NOTE CONFLICT displays if you attempt to set the jukebox controller and a drive to the

same ID. Repeat the procedure and reset one of the IDs to another, non-conflicting

ID.

NOTE After you change an ID you may have to restart your host computer for the new ID

to be recognized.

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 95 96

Keine Kommentare

HP 80ex Bedienungsanleitung Seite 50