HP ZR24W Bedienungsanleitung PDF herunterladen (Seite 20)

The monitor automatically scans the signal inputs for an active input and uses that input for the display.

If two or more inputs are active, the monitor will display the default input source. If the default source is

not one of the active inputs, then the monitor will display the highest ranking priority input in the following

order: DisplayPort, DVI, then VGA. You can change the default source in the OSD by pressing the front

panel menu button and selecting Source Control > Default Source.

Removing the Monitor Pedestal Base

You can remove the monitor panel from the pedestal base to mount the panel on a wall, a swing arm,

or other mounting fixture (purchased separately).

This monitor has a Quick Release mechanism that allows you to easily remove and replace the monitor

panel to the pedestal base.

CAUTION: Before beginning to disassemble the monitor, be sure the monitor is turned off and the

power and signal cables are both disconnected. Also disconnect any USB cables that are connected to

the monitor.

1. Disconnect and remove the signal and power cables from the back of the monitor.

2. Slide the quick release latch (1) on the pedestal base to the side (either right or left).

3. Pull up on the monitor display head (2) to remove it from the base.

Figure 3-11 Removing the Monitor from the Pedestal Base

12 Chapter 3 Setting Up the Monitor ENWW

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 52 53

Keine Kommentare

HP ZR24W Bedienungsanleitung Seite 20