HP ProLiant DL560 Betriebsanweisung PDF herunterladen (Seite 20)

Operations 20

After the display fully ejects, rotate the display sideways to view the LEDs.

Remove the access panel

WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives and the

internal system components to cool before touching them.

WARNING: To reduce the risk of personal injury, electric shock, or damage to the equipment,

remove the power cord to remove power from the server. The front panel Power On/Standby

button does not completely shut off system power. Portions of the power supply and some internal

circuitry remain active until AC power is removed.

CAUTION: For proper cooling, do not operate the server without the access panel, baffles,

expansion slot covers, or blanks installed. If the server supports hot-plug components, minimize

the amount of time the access panel is open.

To remove the component:

1. Power down the server (on page 18).

2. Remove all power:

a. Disconnect each power cord from the power source.

b. Disconnect each power cord from the server.

3. Extend the server from the rack (on page 18).

4. Use a T-15 Torx screwdriver to loosen the security screw on the hood latch.

5. Lift up on the hood latch handle, and then remove the access panel.

Install the access panel

1. Place the access panel on top of the server with the hood latch open. Allow the panel to extend past the

rear of the server approximately 1.25 cm (0.5 in).

2. Push down on the hood latch. The access panel slides to a closed position.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 101 102

Keine Kommentare

HP ProLiant DL560 Betriebsanweisung Seite 20