Action: Your access point allows only a limited amount of time for you to
complete the setup.
Start the setup process again and make sure to complete the setup in the time
allowed.
● Error message: More than 1 SecureEasySetup access point found
Action: Someone else in the vicinity is also using SecureEasySetup to set up a
device.
Cancel the setup and start over.
● Error message: Another device connected to the access point before the device
tried connecting.
Action: Another device in the vicinity connected to your access point before the
printer was able to connect.
Cancel the setup and start over.
● Error message: Low signal
Action: The access point is too far away or there is interference.
In order to establish a good signal between the printer and access point, you
might have to experiment a bit. Assuming the equipment is functioning properly,
try doing the following things separately or in combination:
– If there is a long distance between the computer or access point and the
printer, move them closer.
– If a cordless telephone, microwave, or other device that emits radio signals
transmitting at 2.4 GHz is nearby, move it farther away to reduce radio
interference.
Network Guide
19
Kommentare zu diesen Handbüchern