HP ZBook 17 Mobile Workstation Bedienungsanleitung PDF herunterladen (Seite 63)

Replacing the service door

Replace the service door after accessing the memory module slot, hard drive, regulatory label, and

other components.

1. Slide the service door towards the battery bay (1) until the service door snaps into place (2).

2. Slide the release latch to the left to access the optional screw (3), and then install the optional

screw (4).

3. Slide the release latch to the right to lock the service door (5).

NOTE: If you do not want to use the optional screw, you can store it inside the service door.

4. Insert the battery (see Inserting or removing the battery on page 39).

Replacing or upgrading the hard drive

CAUTION: To prevent information loss or an unresponsive system:

Shut down the computer before removing the hard drive from the hard drive bay. Do not remove the

hard drive while the computer is on, in the Sleep state, or in Hibernation.

If you are not sure whether the computer is off, turn the computer on by pressing the power button.

Then shut down the computer through the operating system.

Removing the hard drive

To remove a hard drive:

1. Save your work and shut down the computer.

2. Disconnect AC power and external devices connected to the computer.

3. Turn the computer upside down on a flat surface.

Using hard drives 53

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 106 107

Keine Kommentare

HP ZBook 17 Mobile Workstation Bedienungsanleitung Seite 63